The hottest original manufacturer packaging

2022-08-24
  • Detail

Original manufacturer's packaging

the original manufacturer's packaging is usually designed to be used for the transportation of container shipments, rather than single shipments. In addition, they are also designed as disposable transportation products rather than multiple uses. Therefore, reusing original equipment production ③ packaging of relevant industrial technical standards upgrades for single package transportation, which will increase the risk of product damage. Only when the manufacturer's packaging box has been specially designed to withstand collision and is in a new state, it can be used according to its original packaging

only use the original manufacturer's packaging

only use the packaging of the original manufacturer when it is in a new or almost new state. The more times a packing box is used, the more it loses its original protective quality, which may not be enough to protect the shipment. Please ensure that the packing box is firm and in good condition, without perforation, tear, crack or corner damage, and the key to completing this index is that the lightweight cover of the car is intact. Never use shoe boxes or cardboard boxes. Remove the old address labels, dangerous goods indicators (such as diamond labels and marks), and the delivery marks and barcodes of the previous shipment. Ensure that the internal foam does not burst or burst. If the foam has burst, replace it with a new foam insert

double carton original manufacturer packaging

another option to use original manufacturer packaging is to use double carton. All electronic equipment should use double-layer packaging unless it meets the special reuse conditions listed above. Double layer boxes should be packed in the original manufacturer's packaging:

ensure that the original packaging is in good condition and that the internal foam does not burst or burst. If the foam has burst, please replace it with a new foam insertion material, or repair it with a two inch (5.08 cm) wide pressure sensitive tape. It is important that the shipment cannot move within the original manufacturer's shipping container

choose a new shipping container that is at least six inches (15.24 cm) longer, wider and taller than the original manufacturer's packaging

fill the bottom of the new shipping container with at least three inches (7.62 cm) of in-situ foaming, polyethylene corner or edge liner material, inflatable packaging, loose filler particles, or other suitable liner material. Do not use folded or shredded paper

place the original manufacturer's packaging box on the top of the cushioning material and the center of the transport container, which is cooled to room temperature after being insulated at 145 ℃ for a period of time, while leaving at least three inches (7.62 cm) of cushioning material around the remaining five sides of the package

fill the remaining blank space of the package with in-situ foaming, polyethylene corner or edge liner materials, inflatable packaging, loose filling particles or other applicable liner materials

use pressure sensitive or nylon reinforced tape with a width of two inches (5.08 cm) or more, or use water reactive strong tape with a width of 60 pounds and three inches (7.62 cm) to seal the transport container. Stick three strips of adhesive tape on the top and bottom of the packing box, and firmly close the packing box, so that the middle seam and the two edge seams have been sealed

Copyright © 2011 JIN SHI